Products

SP1250LE

The SP 1250LE Universal Power Conditioner is a power factor corrected 1250 VA/875 W device designed to enhance utility power or repair failing utility power in traffic, IT or security cabinets.

Space Saving Designed UPS

Clary’s SP 1250LE can also operate as an on-line, dual conversion UPS when configured with the optional battery pack, which extends the reliability of the cabinet when the utility power fails (black out) or falters (brownout). The SP 1250LE system also protects the cabinet by insuring that no harmful power artifacts arrive at the cabinet to destroy or degrade the cabinet electronics. 

PRODUCT SPECIFICATIONS

  • Voltage
    120 VAC (85 VAC to 155 VAC before going to battery, when configured with batteries)

    Frequency
    40 Hz to 70 Hz

  • Voltage
    120 VAC ±3%

    Frequency
    50 Hz or 60 Hz

    Current
    10.4A

    Rating
    1250 VA / 875 W

    Crest Factor Ratio
    50% load up to 4.8:1, 75% load up to 3.2:1, 100% load up to 2.4:1

    THD
    3.00%

    Dynamic Response
    ±4% for 100% step load change 0.5 ms recovery time

    Overload
    110% for 10 sec; 200% for 50 ms

    UPS Protection
    Input and output short circuit, Input and output overload, Excessive battery discharge

  • Temperature
    -40°C to +74°C (-40°F to +165°F)

    Humidity
    0% to 95% non-condensing

    Altitude
    Sea level to 10,000 ft

  • Input
    IEC-320, C14 male connector

    Outputs
    IEC-320, C13 female receptacles (2)

    Dimensions
    H x W x D (in)1.7 x 15.25 x 8.5 (1U)

    Weight (lb)
    8

    Cooling
    Low velocity, Forced air

  • Standard Features
    Power factor corrected input, Fully regenerative, True on-line continuous power, Low distortion sine wave output, Designed for non-linear loads, Extended brownout protection

    Certifications
    FCC Class A, IEEE 587/ANSI C62.4, IEC 555@ 120 VA, NEMA

    Typical Recharge Time
    (to 85% Capacity @ 100% Load)
    3 to 5 hrs with SP 485B battery pack, 48 to 72 hrs with Outpost or Garrison batteries

  • Visual Indicators
    Battery status, AC output, AC input, Alarm

    Switches / Control Panel
    System power, Cold start, Load I, Load II

    Audible Alarms
    Utility interrupt, Inverter failure, Overload, Low battery

    Intelligent Computer Interfaces
    1 each DB9-F (RS232 and signal interface pins) and 1 each USB

  • External Battery Pack
    SP 48SB battery pack. Compact design. Ideal for runtime requirements less than an hour.

PRODUCT DOWNLOADS
Manual (PDF)
Datasheet (PDF)

← Back to Traffic Products

Previous

SP1250DLE-MC
Next

SP1250LX