SP 1400LT

Compact Full Featured 1400 VA / 1000 W Online UPS

SP 1400LT Overview

The SP 1400LT is our space saving full-featured UPS for traffic systems. The LT Series are advanced UPS that provide clean, regulated dual conversion power for controllers and other sensitive equipment inside the traffic cabinet. Rated for 1400 VA / 1000 W, with operational temperature of -40°C to +74°C (-40°F to 165°F), the SP 1400LT has been independently tested and certified to comply with NEMA temperature standards as well as NEMA standards for shock and vibration. So small, lightweight and incredibly flexible in space, the SP 1400 LT can fit in almost all cabinets. Along with its batteries it can even fit in a compact pole mounted cabinet as little as 16" H x 14" W x 12" D. The SP 1400LT provides continued operation during power loss for intersections using LED lights with either Lithium-Iron Phosphate or Lead Acid Batteries. Advanced communication features allow monitoring, configuration and control of the system over RS232, modem or network connections with SMNP. Available with battery bus voltages of 48 V or 72 V.

SP 1400LT Specifications

Voltage 75 VAC to 155 VAC (before going to batteries)
Frequency 45 Hz to 65 Hz
Voltage 120 VAC ±3%
Frequency 50 Hz or 60 Hz
Current 10.4A
Rating 1400 VA / 1000 W
Crest Factor Ratio 50% load up to 4.8:1, 75% load up to 3.2:1, 100% load up to 2.4:1
THD 4.00% maximum
Dynamic Response ±4% for 100% step load change 0.5 ms recovery time
Overload 110% for 10 sec; 200% for 50 ms
UPS Protection Input and output short circuit, Input and output overload, Excessive battery discharge
Temperature -40°C to +74°C (-40°F to +165°F)
Humidity 0% to 95% non-condensing
Altitude Sea level to 10,000 ft
Input Hardwired to bypass box
Outputs Hardwired to bypass box, with single 15 Amp receptacle
H x W x D (in)
3.5 x 11.0 x 8.5 (2U)
Weight (lb) 8
Cooling Low velocity, Forced air
Standard Features Power factor corrected input, Fully regenerative, True on-line continuous power, Low distortion sine wave output, Designed for non-linear loads, Extended brownout protection, EIA/RS232 data interface
Certifications IEEE 587/ANSI C62.4, IEC 555 @ 120 VA, NEMA
Typical Recharge Time
(to 85% Capacity @ 100% Load)
48-72 hrs (more time required with extended battery option)
Switches / Control Panel System power, Cold start, Test, Alarm silence, Four line LCD display panel
Audible Alarms Utility interrupt, Inverter failure, Overload, Low battery, Self test
Intelligent Computer Interfaces ["Serial interface for EIA 232","1 each DB9-F (RS232 and signal interface pins) and 1 each USB","Full interactive remote computer monitoring and control of most features including load control (requires optional monitoring software)","NTCIP and TCP\/IP ready"]
Contact Closures "D" connector, Open collector (see user manual for additional interface information)
SNMP Interface ["Allows full control and monitoring interface over network connection. Compatible with HP Openview\u2122, IBM Netview\u2122, CA Unicenter TNG\u2122, and other major software offerings."]
Battery Bus Voltage 48 V or 72 V

Contact us to learn more about our innovative products!
Contact Us