Monrovia, CA: 800-442-5279 - 626-359-4486 Richmond, VA: 888-442-5279
 

 

 

 

 

The only On-Line Double Conversion UPS system that offers selectable features to meet your application needs. Wide selection of features such as input/output isolation, switchable voltages or auto-sense capability, input circuit breaker protection and input and output termination selection options. Rugged design for applications in extreme temperature environments, offshore drilling rigs, refineries and shipboard use; can double as an electronic power conditioner/frequency converter as well. All CT systems utilize Power Factor Correction, and RS232 and SNMP protocols are supported. Available in a 3U rack-mount configuration with extended battery options. Custom configurations and engineering available. RATINGS: 1,250/1,500/ 2,000/2,400 VA; various input and output voltages available. UL listed.

Clary's customizable CT Series allow the user to tailor the UPS solution for its intended mission-critical application. Clary will build each system to order, according to the customer's selection of input and output voltages, input and output frequency, bypass, isolation, input and output power termination and many other features. Many custom options are available, please contact factory for availability.

DIAGRAMS: Rackmount Chassis
WARRANTY | PRODUCT MANUALS | PRODUCT BROCHURE

   
 
  ELECTRICAL    
  INPUT    
  Voltage Ranges     120 VAC +10%, -20% (Other input voltages available)
  Frequency     45 to 65 Hz
  Current     See Table Below
  OUTPUT    
  Voltage     120 VAC ±3% (Other output voltages available)
  Frequency     Software Selectable to Sync with Input Utility or Run at Crystal Controlled 50 or 60 Hz ±1 Hz
  Current     See Table Below
  Crest Factor Ratio (Non-linear Load and < 5% THD) Typical    
@50% Load Up to 4.8:1
@75% Load Up to 3.2:1
@100% Load Up to 2.4:1
  Total Harmonic Distortion (THD)     3% Max. (Linear)
5% Max. (Non-linear)
  Dynamic Response     ±4% for 100% Step Load Change 0.5 ms Recovery Time
  Overload     110% for 10 min; 200% for .05 sec
  Efficiency @100% Load     88% (90% Typical)
  UPS Protection     Input and Output Short Circuit;Input and Output Overload; Excessive Battery Discharge
  ENVIRONMENTAL    
 

Operating Temperatures:
Standard Models

   
0°C to +40°C (+32°F to +104°F)
  Humidity     0% to 95% Non-condensing
  Altitude     Sea Level to 10,000 ft (some derating of temp. w/altitude)
  Noise Level     39 to 42 dBA at 5 ft
  MECHANICAL    
  Input Connectors      
  1,250/1,500 VA     NEMA 5-15P Plug w/6 ft Cord
  2,000/2,400VA     NEMA 5-20P Plug w/6 ft Cord
  Outputs(Standard)     3 – NEMA Duplex Receptacles 5-15R, 1.25K-1.5K, 5-20R, 2K-2.4K
         
  CUSTOM OPTIONS    
  Contact Factory for Other Custom Options
Specifications subject to change without prior notice.
     
  DESIGN    
  Standard Features     Power Factor Corrected Input; Fully Regenerative; True On-Line; Low Distortion Sinewave Output; Inverter Powers Load Continuously; Designed for Non-linear Loads; Extended Brownout Protection; Continuous Operation on -25% to +12% Utility w/o Draining Batteries; Automatic Bypass; RS232 Data Interface; AC Output - 2 Channel Load Control; Rear Mounted Ground Stud
  Specifications     UL 1778; CUL; FCC Class A; IEEE 587 / ANSI C62.41;IEC 555 @120VAC
  MTBF     In Excess of 100,000 hrs
  Typical Recharge Time
85% Capacity @100% Load
    5 hrs
  CONTROL AND INDICATORS    
  Sequenced LEDs Single LEDs     Battery Level, Load Level AC In, Inverter On, Load On, Summary Alarm, Alarm Silence
  Front Panel Controls     Power On; Cold Start; Alarm Silence; Test; Load I On-Off; Load II On-Off
  Audible Alarms     Utility Interrupt; Inverter Failure; Overload; Low Battery; Self Test
  RS-232 Data Interface (DB-9)     Full Interactive Remote Computer Monitoring and Control of Most Features,
Including Load Control (requires optional monitoring software). Compatible with RUPS tm and RUPS II™ and other major UPS software products.
  Contact Closure (DB-9)     Open Collector or Optional Dry Contact Module
  Optional SNMP Interface     Allows Full Control and Monitoring over a network connection. Compatible with HP Openview™, IBM Netview™, CA Unicenter TNG™ and other major UPS software products.
 

Specifications subject to change without prior notice.

     
Model
Rackmount
VA
Input
Current
(A)
Output
Current
(A)
Backup Time
100% / 50%
Load
Unit
Weight
Short/Std. (lbs)
Optional
Short
Rackmount
H x W x D (in)
Standard
Rackmount
H x W x D (in)
CT1250R
1,250
8.8
10.4
7 / 21
42 / 79
5.25 x 19.0 x 17.0 (3U)
5.25 x 19.0 x 23.0 (3U)
CT1500R
1,500
10.7
12.5
8 / 20
42 / 79
5.25 x 19.0 x 17.0 (3U)
5.25 x 19.0 x 23.0 (3U)
CT2000R
2,000
14.3
16.7
6 / 22
55 / 92
5.25 x 19.0 x 17.0 (3U)
5.25 x 19.0 x 23.0 (3U)
CT2400R
2,400
18.3
20.0
4 / 14
55 / 95
5.25 x 19.0 x 17.0 (3U)
5.25 x 19.0 x 23.0 (3U)
 

150 East Huntington Drive. | Monrovia,CA 91016 | Tel:800-442-5279 or 626-359-4486 | Fax:626-305-0254

Terms of Use COPYRIGHT © 2004 CLARY Corporation All rights reserved